Skip to main content

This Wembley Stairlift was installed into an office building in London. Due to The Equality Act 2010 stating no worker should be discriminated against in the workplace, it is essential workplaces have suitable disabled access incase any of their workers require it.

Our Wembley Stairlift is a low rise lift and therefore blends seamlessly into the building. This is great for listed buildings as they have little/no impact on the visuals and aesthetics of the building. Some of our lifts have been accepted to be installed into listed buildings and therefore is a great way to offer disabled access in these buildings.

Due to this building being on a crowded street with busy paths, disabled access options like ramps are just not feasible. This is due to the incline they require, yet isn't available on these type of premises.

The Wembley Stairliftis a low rise lift for travel up to a height of 200mm. It can act as part of the upper landing, a step, or it can sit flush with lower landing level.

Minimum horizontal pit length


Minimum platform size

1384mm x 1035mm

Maximum rise


Minimum pit depth below lower landing

310mm + cladding

The Lift

The Wembley Stair Lift does not require a wheelstop as the rise of the lift is less than 200mm. Please see On Lift Barriers for more information.

The lift table can be made to accept any cladding, the thicker the cladding the deeper the pit depth.

Nominal Platform dimensions for this lift can vary due to site requirements, however they have minimum dimensions of:

1400mm (l) x 900mm (w) x 0-200mm (h)

Please click on The Lifting Actuator link for more information on the mechanism used to raise and lower the stair lift.

The upper landing barrier

As the rise is less than 200mm with the Wembley Stair Lift there is not a requirement for an upper landing barrier.

Please click on the following link for more information on the Upper Landing Barriers

User type

Wembley Stair Lift is for wheelchair users only, for information as to why this is please click on the following on lift barriers link. Non wheelchair users are often presented with a wheelchair to travel whilst seated on this wheelchair platform stair lift.

System requirements

The Wembley Stair Lift can come with a solid stainless steel skirt to conceal the workings of the lift, or the under lift panel can be made ready to accept any material. Please see Concealing the underside of the lift for more information.

For details on the power supply please see the lift power supply.

For general details on the pit depth please see the lift pit.

If the surrounding area presents a crush zone the lift table can be fitted with safety edges to detect an obstruction. Please see Crush hazards surrounding the moving lift for more information.

Please see The Sesame Stair Lift Controls for more information on the controls for this style of lift.

Variations to the Wembley Stair Lift

The permanently fixed on-lift button post can be upgraded to a rising button post that rises through the lift platform when the stairs retract. The post then retracts completely out of site when not in use. An example for the rising button post can be seen here: Knightsbridge Stair Lift.

The permanently fixed on-lift button postt can also be replaced with a removable hand held post as seen here: Kensington Stairlift in London 1052

If the pit depth is an issue the Sesame Thames Stair Lift sits within a pit depth of 160mm + cladding thickness. This lift can also travel up to 999mm.

If the rise is to travel more than 200mm then the Waterloo Lift allows for a wheelstop that prevents wheelchairs wheels from rolling off the stair lift.


Do you have questions?

Contact us