We manufactured and installed this Kensington Lift into a commercial skyscraper in London. This new building was completed in 2020. It is situated in the London financial district, and stands at 278 m tall with 62 storeys. This building needed carefully designed, modern and state of the art disabled access to offer to any disabled visitors/workers who need accessibility around the building. This is one out of two of the lifts we have installed into this building. Both designed differently but offer the same quality and reliable service to the users.
The Sesame Kensington Stairlift is a set of horizontally retracting stairs that reveal a platform lift for wheelchair access.
Minimum horizontal pit length
1 200 mm
Minimum platform size
1 400 mm x 900 mm
Maximum rise
499 mm
Minimum pit depth below lower landing
441 mm + revêtement
Features
The Lift
The Kensington Stairlift uses our Wheelstop mechanism. A solid stainless steel toe guard that rises around the platform to prevent wheelchair wheels from rolling off the stairlift. Please see On Lift Barriers for more information.
The lift table can be made to accept any cladding material, the thicker the cladding the deeper the pit depth.
Nominal Platform dimensions for this lift can vary due to site requirements. However they are more than or equal to:
1408mm (l) x 1010mm (w) 0 – 499mm (h)
Please see The Lifting Actuator link for more information on the mechanism used to raise and lower the stairlift.
The Stairs
The Kensington Stairlift can accommodate up to 3 stairs or a total rise of 499mm.
Please see the retracting stair technical page for more information.
The Upper Landing Barrier
As the rise is below 500mm we do not need a barrier at the upper landing. It is advisable that the controls are positioned at the upper landing so that a staff member can better protect against the void that is created when the stairs retract.
Please see Upper Landing Barriers for more information.
User Type
The Kensington Stairlift is for wheelchair users only.Non wheelchair users are often presented with a wheelchair to travel whilst seated on this wheelchair platform stair lift.
Please see on lift barriers for more information.
System requirements
For details on the power supply please click on the following lift power supply link
For general details on the pit depth please click on the following lift pit link
The Kensington Stairlift can come with either bellows to reduce the pit depth or a solid stainless steel skirt below the lift. Please click on the following link for more information on the Concealing the underside of the lift
If the surrounding area presents a crush zone the lift table can be fitted with safety edges to detect an obstruction. Please click on the Crush hazards surrounding the moving lift link for more information
Please click on the The Sesame Stair Lift Controls for more information on the controls for this style of lift
Variations to the Kensington Stairlift
If the staircase takes on heavy traffic then an upper landing barrier may be recommended as seen on the Sesame Whitehall DDA Lift regardless of the rise
The on lift permanently fixed button post can be upgraded to a rising button post that rises through the lift table when the stairs retract. The post then retracts completely out of site when not in use. This system with an upper landing rising barrier rather than the gate is know as the Sesame Knightsbridge Stair Lift.
The on lift permanent button post can be replaced with a removable hand held post as seen in the following Kensington Stairlift in London 1052 movie
If the pit depth is an issue the Sesame Thames Stair Lift sits within a pit depth of 160mm + cladding thickness.
If the horizontal pit depth is an issue then the Sesame Victoria Stair Lift with vertically retracting stairs may be a solution.
Udostępnij