Windsor Mobility Lift In London

This Windsor Mobility Lift was manufactured in our factory which is situated in West Byfleet/Surrey and was installed into a modern and contemporary office building in London. This building has many businesses operating inside, and therefore having reliable/modern disabled access is necessary.

The Equality Act 2020 law is a body of law which legislates against prejudice-based actions in the workplace. This ensures nobody is at a disadvantage or discriminated against regardless of their age, disability, gender reassignment, marriage and civil partnership, race, religion or belief, sex, pregnancy and maternity, and sexual orientation.

This law means that a workplace should be access friendly in order to facilitate any workers who may have a disability which requires a wheelchair.

Check out our products and contact us if you want more information

The Windsor Mobility Lift has an automatic gate at the upper landing with a fixed handrail and automatic gate on the rising platform.

Minimum horizontal pit length

500 mm

Minimum platform size

1 633 mm x 1 065 mm

Maximum rise

2 999 mm

Minimum pit depth below lower landing

700 mm

Features

The Lift

The Windsor Mobility Lift has handrails and a gate that sit 1100mm high allowing for standing and seated users. Please see On Lift Barriers for more information.

The lift table can be made to accept any cladding material, the thicker the cladding the deeper the pit depth.

Nominal Platform dimensions for this lift can vary due to site requirements. However, they are more than or equal to:

1633mm (l) x 1063mm (w) 0 – 2999mm (h)

Please see The Lifting Actuator link for more information on the mechanism used to raise and lower the mobility lift.

The Upper Landing Barrier

The Windsor Mobility Lift has an automatic gate at the upper landing to protect the fall hazard that is created when the stairs retract.

The spatial requirement for the gate can be adapted to suit the availability of the site.

Please see Upper Landing Barriers for more information.

The On-Lift Barrier

The Windsor Mobility Lifts automatic gate style can be specified by the client, so too can the surrounding handrails. Please see What barriers do I need on the Sesame chair lift? for more information.

System Requirements

The Windsor Mobility Lift can come with either bellows to reduce the pit depth or a solid stainless steel skirt below the lift. Please see concealing the underside of the lift for more information.

For details on the power supply please see the lift power supply.

For general details on the pit depth please see the lift pit.

If the surrounding area presents a crush zone the lift table can be fitted with safety edges to detect an obstruction. Please see Crush hazards surrounding the moving lift for more information.

Please see The Sesame Stair Lift Controls for more information on the controls for this style of lift.

Variations to the Windsor Mobility Lift

The permanently fixed on-lift handrails and gate can be replaced with rising barriers. These lower out of view and sit flush with lower landing level when not in use as seen here: Richmond Rising Platform Lift. This lift also shows a rising barrier at the upper landing as an alternative to the automatic gate.

If the pit depth is an issue the Sesame Jubilee Disabled Access Lift sits within a pit depth of 160mm + cladding thickness. This example also shows an option of a manual gate at the upper landing.

Udostępnij

Czy masz pytania?

Skontaktuj się z nami